TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1223 of 1824

TM 9-2320-366-20-1

VOLTAGE TEST

(13) Connect connector P65 to connector J65.

(14) Install kick panel (para 16-3).

(1) Remove seven screws and washers from

kick panel.

(2) Remove kick panel and stiffener from

dashboard.

(3) Disconnect connector P65 from connector

J65.

(4) Set multimeter to volts dc.

(5) Connect positive (+) probe of multimeter

to connector P65-1.

(6) Connect negative (-) probe of multimeter to

ground.

(7) Position main light switch to SER DRIVE

(TM 9-2320-366-10-1).

(8) Position warning light switch to on

(TM 9-2320-366-10-1).

(9) If 12 vdc is not present, repair wire 509

(para 2-45)or replace WTEC II dashboard

cable assembly (para 7-10) or WTEC III

dashboard cable assembly (para 7-11).

(10) If 12 vdc is present, repair wire 509

(para 2-45) or replace warning light cable

assembly (para 22-5).

(11) Position warning light switch to off

(TM 9-2320-366-10-1).

(12) Position main light switch to OFF

(TM 9-2320-366-10-1).

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle.

Jewelry can catch on equipment and

cause injury or short across electrical circuits

and cause severe burns or electrical shock.

WARNING

2-669

TM 9-2320-366-20-1