TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1321 of 1824

TM 9-2320-366-20-1

Change 1

2-758.1

NOTE

CONTINUITY TEST

(1) Disconnect turn signal switch connector

from connector J19.

(2) Set multimeter to ohms.

(3) Connect positive (+) probe of multimeter

to PDP, terminal 30, where relay K10 was

removed.

(4) Connect negative (-) probe of multimeter

to connector J19 socket 6.

(5) If continuity is not present, repair wire

1594 from relay K10 terminal 30 to

connector J19 socket 6 (para 2-45) or

replace WTEC II dashboard cable

assembly (para 7-10) or WTEC III

dashboard cable assembly (para 7-11).

(6) If continuity is present, replace relay K10

(para 7-9).

(7) Connect connector J19 to turn signal

switch connector.

(8) Install instrument panel assembly

(para 7-15).

(9) Install relay K10 in PDP.

(10) Install PDP cover (para 16-2).

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION