TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 927 of 1824

CONTINUITY TEST

TM 9-2320-366-20-1

Change 1

2-600.11

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

(1)

Disconnect batteries (para 7-57).

(2)

Remove PDP cover (para 16-2).

(3)

Remove three screws and washers from

PDP.

(4)

Remove three screws from PDP.

(5)

Lift PDP outward to gain access.

(6)

Disconnect connector P51 from connector

J51.

(7)

Set multimeter to ohms.

(8)

Connect positive (+) probe of multimeter

to connector J51 pin 7.

(9)

Connect negative (-) probe of multimeter

to terminal board TB1 position 11 and note

reading on multimeter.

(10)

If continuity is not present, repair wire 489

from connector J51 pin 7 to terminal board

TB1 position 11 (para 2-45) or replace

WTEC II dashboard cable assembly

(para 7-10) or WTEC III dashboard cable

assembly (para 7-11).

(11)

If continuity is present, repair wire 489

from connector P51 socket 7 to splice

E15 (para 2-45) or replace rear lights

cable assembly (para 7-84).

NOTE

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION

(12)

Connect connector J51 to connector P51.

(13)

Install PDP on dashboard with three

screws.

(14)

Install three washers and screws in PDP.

(15)

Install PDP cover (para 16-2).

(16)

Connect batteries (para 7-57).