TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 933 of 1824

CONTINUITY TEST

Change 1

2-604.1

TM 9-2320-366-20-1

Wire 3094 from Terminal Lug TL15

to Terminal Lug TL16

TL15

LH Side

LH Rear

TL16

Replace Marker Light (para 7-38)

Wire 3094 from Terminal Lug TL31

to Terminal Lug TL30

Left Rear

TL30

Replace Marker Light (para 7-38)

Replace Marker Light (para 7-38)

Replace Marker Light (para 7-38)

TL31

TL32

Middle Rear

Right Rear

RH Rear

TL20

Wire 3095 from Terminal Lug TL19

to Terminal Lug TL20

TL19

RH Side

Table 2-12.1.

M1083/M1084/M1090/M1092/M1093/M1094

Side and Rear Marker Light Terminal Lugs

Marker Light

Connector

Wire Segment

(1) Remove nut, lockwasher, terminal lug, and

lockwasher from marker light screw.

Discard lockwashers.

(2) Set multimeter to ohms.

(3) Connect positive (+) probe of multimeter

to terminal lug (refer to Table 2-12.1.

M1093/M1084/M1090/M1090/M1092/

M1093 Side and Rear Marker Light

Terminal Lugs).

(4) Connect negative (-) probe of multimeter to

ground and note reading on multimeter.

(5) If continuity is not present, repair wire

(refer to Table 2-12.1.

M1093/M1084/

M1090/M1090/M1092/M1093 Side and

Rear Marker Light Terminal Lugs)

(para 2-45) or replace rear lights cable

assembly (para 7-84).

(6)

If continuity is present, replace marker

light (para 7-38).

(7)

Install lockwasher and terminal lug on

marker light screw with lockwasher and

nut.