TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 931 of 1824
VOLTAGE TEST
Change 1
2-603
TM 9-2320-366-20-1
(1)
Disconnect marker light connector from
connector (refer to Table 2-12.
M1083/
M1084/M1090/M1092/M1093/M1094
Side and Rear Marker Light Connectors).
(2)
Set multimeter to volts DC.
(3)
Connect positive (+) probe of multimeter
to connector (refer to Table 2-12.
M1083/M1084/M1090/M1092/M1093/
M1094 Side and Rear Marker Light
Connectors).
(4)
Connect negative (-) probe of multimeter
to ground.
(5)
Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading
on multimeter.
(6)
Position main light switch to OFF
(TM 9-2320-366-10-1).
(7)
If 12 VDC is not present, repair wire 489
(refer to Table 2-12.
M1083/M1084/
M1090/M1092/M1093/M1094 Side and
Rear Marker Light Connectors)
(para 2-45) or replace rear lights cable
assembly (para 7-84).
Inspect connector pins/sockets for damage,
corrosion, and serviceability.
Check that
connector pins are not pushed back and
are capable of making good contact.
NOTE
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes.
Failure to comply
may result in damage to equipment.
CAUTION
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle.
Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
WARNING
Marker Light
Connector
LH
Side
LH
Rear
Left
Rear
Middle
Rear
Right
Rear
RH
Rear
RH
Side
P85
P86
P54
P56
P58
P89
P88
Connector P85 to Splice
Wire 489 Segment
Connector P86 to Splice
Connector P54 to Splice
Connector P56 to Splice
Connector P58 to Splice
Connector P89 to Splice
Connector P88 to Splice
Table 2-12.
M1083/M1084/M1090/M1092/M1093/
M1094 Side and Rear Marker Light Connectors
Back to Top
