TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006
CHANGE 3

  TM-9-2320-366-20-1 - Page 967 of 1824

CONTINUITY TEST
Change 1
2-604.35
TM 9-2320-366-20-1
(1)
Remove nut, lockwasher, terminal lug TL15,
and lockwasher from LH side marker light
screw.
Discard lockwashers.
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter to
terminal lug TL15.
(4)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5)
If continuity is not present, repair wire 3094
from terminal lug TL15 to terminal lug TL16
(para 2-45) and go to step 5 of this fault if
required or replace rear lights cable assembly
(para 7-84) and go to step 1 of this fault.
(6)
If continuity is present, replace LH side
marker light (para 7-38) and go to step 5
of this fault if required.
(7)
Install lockwasher, terminal lug TL15,
lockwasher, and nut on LH side marker
light screw.
(8)
Connect LH side marker light connector to
connector P85.


Back to Top