Remove nut, lockwasher, terminal lug TL16
and lockwasher from LH marker light screw.
Connect positive (+) probe of multimeter to
terminal lug TL16.
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
If continuity is not present, repair wire 3094
from terminal lug TL16 to terminal lug TL18
(para 2-45) and go to step 30 of this fault if
required or replace rear lights cable assembly
(para 7-84) and go to step 1 of this fault.
If continuity is present, replace LH marker
light (para 7-38) and go to step 31 of this
(6) Install lockwasher, terminal lug TL16,
lockwasher, and nut on LH marker light
(7) Connect LH marker light connector to