TM-9-2320-366-20-4

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 4 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-4 - Page 609 of 1558

TM 9-2320-366-20-4

(18) Install inner bevel side gear (15) on spindle (12).

CAUTION

If alignment pins on wheel bearing nut do not

line up with alignment holes on inner bevel

side gear, loosen wheel bearing nut until pins

and holes are aligned. Do not loosen wheel

bearing nut more than one spline tooth.

Failure to comply will result in damage to

equipment.

(19) Align pins (16) on wheel bearing nut (14) with alignment

holes in inner bevel side gear (15).

(20) Remove inner bevel side gear (15) from spindle (12).

NOTE

• Record measurement taken in step (21).

• Steps (21) through (24) are not required when

packing

wheel

bearings

for

Preventive

Maintenance Checks and Services (PMCS).

(21) Measure depth from surface of wheel bearing

nut (14) to face of wheel end hub (2).

Change 1

10-9