TM-9-2320-366-20-4

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 4 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-4 - Page 658 of 1558

TM 9-2320-366-20-4

11-5. REAR BRAKE PLUNGER ASSEMBLY REPLACEMENT/REPAIR (CONT)

e. Installation.

CAUTION

Adjusting sleeve must bottom on shoulder

inside plunger.

Threading adjusting screw

too far into adjusting sleeve will cause

automatic adjuster not to function.

NOTE

Install plungers in same location as removed

and align keyways in anchor/ adjusting

plungers with hole in plunger housings.

(1) Install adjusting plunger assembly (1) in plunger housing

(2).

NOTE

Make certain grooves in pawl assembly end

engage in adjusting sleeve grooves.

(2) Position lockwasher (3) and pawl assembly (4) in plunger

housing (2).

(3) Tighten pawl assembly (4) to 15-25 lb-ft (20-34 N·m).

NOTE

• One anchor (solid) and one adjusting plunger

must be installed in each plunger housing.

• Install anchor plunger marked "L" in left plunger

housing. Install anchor plunger marked "R" in

right plunger housing.

(4) Apply film of grease on anchor plunger (5).

(5) Install and seat seal (6) and anchor plunger (5) in

plunger housing (2).

(6) Position lockwasher (7) and guide screw (8) in plunger

housing (2).

(7) Tighten guide screw (8) to 15-25 lb-ft (20-34 N·m).

11-28