TM-9-2320-366-20-4

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 4 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-4 - Page 698 of 1558

TM 9-2320-366-20-4

11-10. LOAD SENSING VALVE AND CONTROL CABLE REPLACEMENT/ADJUSTMENT

(CONT)

NOTE

• If air chamber pressure is not within limits shown

in

Table 11-2. Air Chamber Pressure Limits

perform steps (23) through (25), depress brake

pedal several times, shut down engine, and

perform steps (19) through (22) again.

• Lengthening load sensing valve control cable

will increase pressure reading, shortening cable

will decrease pressure reading.

(23) Loosen screw (7) in cable clamp (1).

(24) Adjust length of load sensing valve control cable (6).

(25) Tighten screw (7) in cable clamp (1).

(26) Tighten jam nut (17) on screw (7).

(27) Shut down engine (TM 9-2320-366-10-1).

(28) Drain air from primary air tank (TM 9-2320-366-10-1).

(29) Disconnect test cable (16) from pressure transducer (15).

(30) Remove pressure transducer (15) from tee fitting (14).

(31) Disconnect air hose (9) from 90-degree fitting (10).

(32) Remove 90-degree fitting (10) from left rear service

brake air chamber (11).

(33) Disconnect center air hose (12) from 90-degree fitting

(13).

(34) Remove 90-degree fitting (13) from tee fitting (14).

(35) Remove tee fitting (14) from left rear service brake air

chamber (11).

11-68

Change 1