TM-9-2320-366-34-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 1 OF 4

AUGUST 2005
CHANGE 2

  TM-9-2320-366-34-1 - Page 1226 of 1591

WARNING
Dump body weighs approximately 3,030 lbs.
(1,376 kgs).
Attach a suitable lifting device
prior to lifting. Failure to comply may result in
injury to personnel.
Wear approved eye protection when performing
pressure checks.
Failure to comply may result
in oil getting into eyes.
If oil contacts eyes,
seek medical attention immediately.
PRESSURE TEST
NOTE
Change 2
2-1069/(2-1070 Blank)
Prolonged contact with lubricating oil (MIL-L-21
04) may cause a skin rash.
Skin and clothing
that come in contact with lubricating oil should
be thoroughly washed immediately.
Saturated
clothing should be removed immediately.
Areas
in which lubricating oil is used should be well
ventilated to keep fumes to a minimum. Failure
to comply may result in injury to personnel.
Drop hydraulic pressure to zero before
disconnecting any hydraulic line.Failure to
comply may result in injury to personnel.
Lubricating oil is slippery and can cause falls.
Wipe up spilled oil with rags.
Failure to comply
may result in injury to personnel.
Test continued on page 2-1070.1.
(1) Remove safety pin from two locking pins.
(2) Remove two locking pins from dump body.
(3) Install two dump body lifting brackets in slots
in dump body.
(4) Attach cargo sling to dump body lifting
brackets.
(5) Lift dump body.
(6) Raise two maintenance legs on frame.
(7) Lower dump body on maintenance legs.
(8) Position drain pan under vehicle.
(9) Remove cap from 90-degree fitting on port P
of the four-way relief valve.
Route test hose between frame and exit
under vehicle.
(10) Install adapter and test hose on 90-degree
fitting.
(11) Instal pressure transducer (0-10,000 PSI
[0-68,965 kPa]) on test hose.
(12) Connect pressure test cable to pressure
transducer and to Test Set.
(13) Start engine (TM 9-2320-366-10-1).
(14) Position PTO switch to on
(TM 9-2320-366-10-1).
TM 9-2320-366-34-1


Back to Top