Change 1
2-201
TM 9-2320-366-34-1
RESISTANCE TEST
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter to
pin A of A solenoid connector.
(3)
Connect negative (-) probe of multimeter to
pin B of A solenoid connector and note
reading on multimeter.
(4)
If resistance is less than 2.5 ohms or
greater than 5.0 ohms, replace A solenoid
(para 7-8).
(5)
If resistance is between 2.5-5.0 ohms,
replace WTEC II TEPSS (TM 9-2320-366-
20-4).
(6)
Connect internal wiring harness
connector A to A solenoid connector.
(7)
Install cover on control valve module with
four screws.
(8)
Install control valve module (para 7-10).
(9)
Connect batteries (TM 9-2320-366-20-3).