TM-9-2320-366-34-3

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 3 OF 4

AUGUST 2005
CHANGE 2

  TM-9-2320-366-34-3 - Page 822 of 1178

TM 9-2320-366-34-3
16-91. HYDRAULIC ROTARY PUMP REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-on Maintenance
INITIAL SETUP
Equipment Conditions
Splash guard removed (TM 9-2320-366-20-4).
Air cleaner removed (TM 9-2320-366-20-3)
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 92, Appendix
B)
Goggles, Industrial (Item 28, Appendix B)
Materials/Parts
Cap and Plug Set (Item 17, Appendix C)
Packing, Preformed (Item 230, Appendix F)
Packing, Preformed (Item 233, Appendix F)
Dispenser, Pressure Sensitive Adhesive Tape (Item
30, Appendix C)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working
under
vehicle
due
to
the
possibility
of falling debris. Failure to
comply may result in injury to personnel.
a. Removal.
CAUTION
Cap or plug hydraulic hoses and fittings to
prevent contamination of hydraulic system.
Failure to comply may result in damage to
equipment.
NOTE
Tag hydraulic hoses and connection points
prior to disconnecting.
(1) Disconnect hydraulic hoses (1) and (2) from fitting (3)
and 90 degree fitting (4).
NOTE
Step (2) requires the aid of an assistant.
(2) Remove two screws (5), washers (6), and hydraulic
rotary pump (7) from PTO (8).
16-562


Back to Top