TM-9-2320-366-34-3

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 3 OF 4

AUGUST 2005

CHANGE 2

TM-9-2320-366-34-3 - Page 852 of 1178

TM 9-2320-366-34-3

16-584

Change 2

16-93.

POWER TAKE-OFF (PTO) REPLACEMENT/REPAIR (CONT)

(10) Remove drive shaft (10) from frame (11).

(11) Position universal joint (12) on drive yoke (13) with

two bearing cups (14) and four screws (15).

(12) Tighten four screws (15) to 26-35 lb-ft (35-47 N•m).

WARNING

CAUTION

NOTE

Step (10) requires the aid of an assistant.

Do not use steel hammers to seat bearing

cups in drive yokes.

Failure to comply

may result in injury to personnel or

damage to equipment.

Check bearing cups to ensure all needle

bearing are in place prior to installation.

Replace bearing cups if needle bearings

are missing or out of place.

Failure to

comply may result in damage to

equipment.

NOTE

•

Wipe end of yoke bearing bores prior to

installation.

•

There are two types of bearing cups,

those with tabs and those without.

Perform step (11) on bearing cups not

equipped with tabs.

NOTE

Perform step (12) on kits equipped with

screws P/N C5 H5 24-39.