TM-9-2320-387-24-1
TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 1
DECEMBER 1997
CHANGE 1
TM-9-2320-387-24-1 - Page 632 of 1205
TM 9-2320-387-24-l
3-33. FUEL FILTER MAINTENANCE
--
This task covers:
a.
Removal
b.
Installation
c.
Bleeding
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
hIaterials/Parts
‘Itvo
lo&washers (Appendix G, Item 207)
Fuel filter bleeder tool (Appendix D, Fig. D-38)
(optional)
Sealing compound (Appendix C, Item 61)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment
Condition
l
Hood raised and secured (TM 9-2320-387-10).
l
Engine access cover removed (para. 10-22).
l
Fuel pressure transducer removed (para. 4-30).
General Safety Instructions
Do not perform this procedure near fire, flames, or
sparks.
Maintenance
Level
Unit
WARNING
Diesel fuel is highly flammable. Do not perform this procedure near
fire, flames, or sparks. Severe injury or death may result.
-1
CAUTION
Cover or plug all hoses and connections
immediately afbar disconnection
to prevent contamination. Remove all plugs prior to connection.
NOTE
Have drainage container ready to catch fuel.
1.
Loosen two hose clamps (2) and disconnect fuel inlet hose (1) and fuel outlet hose (12) from fuel filter
fittings (5).
2.
Loosen hose clamp (8) and disconnect fuel filter drain hose (9) from fuel filter fitting (5).
3.
Pull back insulation to allow access to
capscrews
(31, and remove two capscrews (3), lockwashers (41,
and fuel filter bracket (10) from body (11). Discard lockwashers (4).
4.
Loosen capscrew (6) and remove fuel filter (7) from fuel filter bracket (10).
5.
Remove three fittings (5) from fuel filter (7).
.-
1
b. Installation
1
1.
Apply sealing compound to threads of three fittings (5). Install fittings (5) on fuel filter (7).
2.
Install fuel filter (7) on fuel filter bracket (10) and tighten capscrew (6).
3.
Install fuel filter bracket (10) on body (11) with two lockwashers (4) and capscrews (3). Tighten
capscrews (3) to 15 lb-ft (20 N-m).
4.
Connect drain hose (9) to fuel filter fitting (5) and tighten clamp (8) to lo-20 lb-in. (1-2 Nom).
5.
Connect fuel inlet hose (1) and fuel outlet hose (12) to fuel filter fittings (5) and tighten two clamps (2)
to lo-20 lb-in. (l-2 Nom).
-
3-64
Back to Top
