TM-9-2320-387-24-1
TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 1
DECEMBER 1997
CHANGE 1
TM-9-2320-387-24-1 - Page 768 of 1205
TM
9-2320-387-24-l
4-20.
WAIT-TO-START LAMP REPLACEMENT
I
This task covers:
a.
Removal
h.
Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment
Condition
l
Battery ground cables disconnected (para. 4-68).
l
Instrument cluster removed (para. 4-14).
Maintenance
Level
unit
NOTE
Prior to removal, tag leads and note position for instaIIation.
pIYiizq
-
1.
Loosen nut (14) and lower steering column (7).
2.
Remove cannon plug (16) from main light switch (15).
3.
Remove two capscrews (171, washers (181, nuts (201, and washers (18) from instrument panel (6) and
body (19).
4.
Remove nut (22) and screw (23) from hand throttle bracket (21) and instrument panel (6).
5.
Remove nut (131, washer (111, capscrew (101, and washer (11) from instrument panel (61, hand
throttle bracket (211, and steering column bracket (12).
6.
Remove screw (8) from instrument panel (6) and cowl (9).
7.
PuII instrument panel (6) away from body (19).
8.
Remove two screws (5) from wait-to-start lamp (4) and instrument panel (6).
9.
Disconnect leads 571(2) and 27 (3) from wiring harness (1).
10.
Remove wait-to-start lamp (4).
-1
1.
2.
3.
4.
5.
6.
Connect leads 571(2) and 27 (3) to wiring harness (1).
InstaIl wait-to-start lamp (4) on instrument panel (6) with two screws (5).
Install instrument panel (6) on cowl (9) with screw (8).
Install instrument panel (6) and hand throttle bracket (21) on steering column bracket
(12)
with
washer (111, capscrew (lo), washer (ll), and nut (13).
Install hand throttle bracket (21) on instrument panel (6) with screw (23) and nut (22).
Install instrument panel (6) on body (19) with two washers (181, capscrews (171, washers (18), and
nuts (20).
7.
Install cannon plug (16) on main light switch (15).
8.
Raise steering column (7) and tighten nut (14) to 31 lb-R (42 N-m).
4-42
Back to Top
