TM-9-2320-431-10-1
TRUCK, WRECKER, 8X8, M984A1
TECHNICAL MANUAL; OPERATOR'S MANUAL; PART 1 OF 2
JUNE 2009
TM-9-2320-431-10-1 - Page 1020 of 1244
PREPARE CRANE FOR OPERATION - Continued
11.
Push and release LATCH switch (9). Engine speed will increase to approximately
1500 rpm.
SETUP OUTRIGGERS
WARNING
•
Chock front wheels when using outriggers to prevent vehicle from
rolling. Failure to comply may result in injury or death to personnel.
•
Stand clear of outrigger beams while operating lever. Failure to
comply may result in injury or death to personnel.
NOTE
•
Always operate control levers with light, even pressure.
•
Outrigger beams can only be extended/retracted from controls on
same side of vehicle.
•
Outrigger beams will come out slower with light pressure on lever.
Pushing lever to full travel will cause faster movement.
•
Either right or left outrigger may be extended first, for the purposes
of this procedure; the right side is extended first.
1.
Move O/R EXT control lever (1) to IN position briefly and lift and turn right outrigger
lockpin (2) to unlock position.
TM 9-2320-431-10-1
0106
0106-4
Back to Top
