TM-9-2320-434-10

TRUCK, LOAD HANDLING SYSTEM (LHS), 8X8, M1120

TECHNICAL MANUAL; OPERATOR'S MANUAL

JUNE 2009

TM-9-2320-434-10 - Page 525 of 1324

LOADING - Continued

WARNING

Maximum side slope when loaded with an FRS or container is 30%.

Failure to comply may result in injury or death to personnel and damage

to equipment.

WARNING

Do not reduce tire pressure when loaded with FRS or container. Highway

tire pressure, 60 psi (414 kPa) front and 83 psi (572 kPa) rear, is required

at all times when loaded with FRS or container. If equipped with armor

kit, highway tire pressure 75 psi (517 kPa) front is required at all times.

Failure to comply may result in injury or death to personnel and damage

to equipment.

CAUTION

Engine speed must be at idle before using hydraulic selector switch, or

damage to equipment may result.

25.

Turn hydraulic selector switch (6) to OFF.

UNLOADING

NOTE

Continued repetitive cycles (approximately nine) at rated 26,000 lbs (11

804 kg) for the load handling system (LHS) or 24,000 (10 896 kg) for the

load handling system (LHS) with container handling unit (CHU) could

cause overheating, and system failure to pick up the load. Allow the

hydraulic system to cool for approximately 1 1/2 hours, or until you can

hold your hand on the reservoir for more than 10 seconds.

1.

Check area for sufficient operating room at front and rear of vehicle. Check overhead

clearance and ground conditions.

TM 9-2320-434-10

0064

0064-11