TM-9-2320-434-10

TRUCK, LOAD HANDLING SYSTEM (LHS), 8X8, M1120

TECHNICAL MANUAL; OPERATOR'S MANUAL

JUNE 2009

TM-9-2320-434-10 - Page 552 of 1324

UNLOADING - Continued

9.

When back edge of flatrack touches ground, release service brake pedal (1), allowing

vehicle to be pushed straight from under flatrack.

10.

Continue off-loading until front of flatrack is within 8 in. (20.32 cm) of ground, decrease

engine speed to idle, and apply service brake pedal (1).

CAUTION

Once suspension has been relieved of flatrack load, do not continue in

UNLOAD position or rear of vehicle could jack up with hook arm and

equipment damage may result.

11.

Continue off-loading until flatrack is on ground and rear suspension is unloaded.

12.

Release joystick (6).

NOTE

•

Engine speed should be set at idle. However, slight increase in

engine speed may be necessary depending on terrain.

•

LHS will only operate when transmission range selector is in N

(neutral).

13.

Set transmission range selector (2) to D (drive) and release service brake pedal (1).

Set transmission range selector (2) to N (neutral).

14.

Move joystick (6) to LOAD position momentarily, and then to UNLOAD position to let

LHS lift hook (8) disengage from flatrack hook bar (9). Repeat Step (14) until LHS lift

hook (8) disengages from flatrack hook bar (9).

TM 9-2320-434-10

0065

0065-20