TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 324 of 1616

TM 9-2320-440-13&P

0034-6

0034

END OF WORK PACKAGE

MAIN FRAME DOES NOT LOAD IN MANUAL MODE (CONTINUED)

WARNING

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment or

severe burns or electrical shock to personnel.

NOTE

•

Perform Step 8 if 22 to 28 vdc are not present on wire 1465A at connector REC1,

terminal 2 in Step 6.

•

Perform Step 9 if 22 to 28 vdc are not present on wire 1465B at connector REC1,

terminal 3 in Step 6.

Step 8.

Disconnect THAAD control valve harness VIM No. 1, 40 pin connector (WP 0089).

Check for continuity across wire 1465A from VIM No. 1, 40 pin connector, terminal 15 to

REC1 connector, terminal 2.

a.

If there is continuity, replace VIM No. 1 (WP 0089).

b.

If there is no continuity, repair wire 1465A (TM 9-2320-325-14&P) or

replace THAAD control valve harness (WP 0088).

Step 9.

Disconnect THAAD control valve harness VIM No. 2, 40 pin connector (WP 0089).

Check for continuity across wire 1465B from VIM No. 2, 40 pin connector, terminal 15 to

REC1 connector, terminal 3.

a.

If there is continuity, replace VIM No. 2 (WP 0089).

b.

If there is no continuity, repair wire 1468B (TM 9-2320-325-14&P) or

replace THAAD control valve harness (WP 0088).

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION