TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 331 of 1616

TM 9-2320-440-13&P

0035-7/(8 blank)

0035

END OF WORK PACKAGE

MAIN FRAME DOES NOT UNLOAD IN MANUAL MODE (CONTINUED)

THAAD0705

WARNING

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment or

severe burns or electrical shock to personnel.

NOTE

•

Perform Step 8 if 22 to 28 vdc are not present on wire 1468A at connector REC2, terminal

2 in Step 6.

•

Perform Step 9 if 22 to 28 vdc are not present on wire 1468B at connector REC2, terminal

3 in Step 6.

Step 8.

Disconnect THAAD control valve harness VIM No. 1, 40 pin connector (WP 0089).

Check for continuity across wire 1468A from VIM No. 1, 40 pin connector, terminal 18 to

REC2 connector, terminal 2.

a.

If there is continuity, replace VIM No. 1 (WP 0089).

b.

If there is no continuity, repair wire 1468A (TM 9-2320-325-14&P) or

replace THAAD control valve harness (WP 0088).

Step 9.

Disconnect THAAD control valve harness VIM No. 2, 40 pin connector (WP 0089).

Check for continuity across wire 1468B from VIM No. 2 output connector, terminal 18 to

REC2 connector, terminal 3.

a.

If there is continuity, replace VIM No. 2 (WP 0089).

b.

If there is no continuity, repair wire 1468B (TM 9-2320-325-14&P) or

replace THAAD control valve harness (WP 0088).

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION