TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 351 of 1616

TM 9-2320-440-13&P

0037-13

0037

MRP DOES NOT EXTEND (CONTINUED)

THAAD0638

WARNING

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment or

severe burns or electrical shock to personnel.

CAUTION

•

The MRP subframe to deck lock safety interlock is bypassed in this procedure.

If

MRP rack is loaded, the subframe to deck lock must be disengaged before

operating deck elevation cylinders.

Failure to comply will cause damage to

equipment.

•

The MRP under run bumper safety interlock is bypassed in this procedure.

If MRP

rack is loaded, the under run bumper must be stowed before operating deck

elevation cylinders.

Failure to comply will cause damage to equipment.

Step 18.

Disconnect THAAD chassis harness MUJB connector from MUJB. Connect jumper

wires between MUJB connector terminals B and A, B and R, B and T, and B and b.

Connect another jumper wire between MUJB connector terminals P and M and

P and X. Ensure subframe to deck lock is disengaged and under run bumper is stowed

(refer to THAAD Launcher IETM). Start engine (

Operate MRP

elevation cylinders (WP 0007). Check if MRP elevation cylinders extend and retract.

If MRP elevation cylinders operate correctly, retract elevation cylinders to the

stowed position (WP 0007), shut off engine (

remove

jumpers, connect MUJB connector, and troubleshoot MRP interlocks using

THAAD Launcher IETM.

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

TM 9-2320-347-10)

TM 9-2320-347-10)