TM-9-2320-440-13-P

TERMINAL HIGH ALTITUDE AREA DEFENSE (THAAD) CARRIER

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

AUGUST 2010

TM-9-2320-440-13-P - Page 636 of 1616

TM 9-2320-440-13&P

0076-4

0076

INSTALLATION

WARNING

Remove all jewelry such as rings, dog tags, bracelets, etc.

If jewelry or tools

contact positive electrical circuits, a direct short may result.

Damage to equipment

and injury or death to personnel may occur.

NOTE

•

Perform steps (1) through (18) if sensor plate was removed.

•

LHS is being raised to expose area on hook arm to install sensor plate.

•

LHS will only operate when transmission range selector is in (N).

1.

Connect batteries (TM 9-2320-325-14&P).

2.

Start engine and stow LHS (WP 0011).

3.

Put PTO ENGAGE switch (22) in ON position. Make sure indicator light (23) illuminates.

4.

Turn hydraulic selector switch (24) to MAN HOOK ARM position and raise hook arm (21) until hook arm

cylinder pivot pin (25) is 25 in. (63.5 cm) from LHS main frame (19).

5.

Turn hydraulic selector switch (24) to MAN MAIN FRAME position and raise LHS main frame (19) until hook

arm cylinder pivot pin (25) is 45 in. (114.3 cm) from LHS main frame (19).

6.

Shut off engine (

7.

Disconnect batteries (TM 9-2320-325-14&P).

THAAD0059

TM 9-2320-347-10)