TM-9-2330-247-14-P
CHASSIS, TRAILER: GENERAL PURPOSE, 3-1/2 TON, 2-WHEEL, M353
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS)
MARCH 1992
TM-9-2330-247-14-P - Page 91 of 320
TM 9-2330-247-14&P
4-27.
INTERVEHICULAR CABLE (Con’t)
ACTION
LOCATION
ITEM
REMARKS
7.
Clamp (16)
Two screws (3),
Using no. 2 cross-tip screwdriver and ZG in. open-
nuts (14), and
end wrench, unscrew and take off.
Iockwashers (15)
Ground wire (18) will come free.
8.
lntervehicular
Clamp (16)
Take off.
cable (5)
REPAIR
NOTE
Repair is limited to connector repair (para 4-26) and ground
wire repair (step 9).
9.
Ground wire
(18)
INSTALLATION
10.
Intervehicular
cable leads (19)
and chassis wiring
harness leads (21)
11.
Intervehicular
cable (5)
12.
Clamp (16) and
frame (2)
13.
Intervehicular
cable (5)
14.
Clamp (6)
15.
Intervehicular
cable (5)
16.
Clamp (11)
Ground terminal
(17)
12 connectors
(20)
Clamp (16)
Two screws (3),
Iockwashers (15),
nuts (14), and
ground wire (18)
Clamp (6)
Two screws (4),
Iockwashers (7),
and nuts (8)
Clamp (11)
Screw (12),
Iockwasher (10),
nut (9), and
spring (13)
a. Using stripper, cut off ground terminal (17) and
strip ground wire (18) ~ in. (6.35 mm).
b. Place new ground terminal (17) on ground wire
(18) end and crimp using crimping tool.
Put together and push into clips (1).
Put on intervehicular cable (5) and aline with screw
holes in frame (2).
a. Put screws (3) through screw holes in frame
(2) and clamp (16).
b. Put ground terminal (17) on bottom screw.
c. Put lockwashers (15) and nuts (14) on screws (3).
d. Tighten using no. 2 cross-tip screwdriver and
X6 in. open-end wrench.
Put on intervehicular cable (5) and aline with screw
holes in frame (2).
a. Put screws (4) through screw holes in frame
(2) and clamp (6).
b. Put lockwashers (7) and nuts (8) on screws (4).
c. Tighten using no. 2 cross-tip screwdriver and
XG in. open-end wrench.
Put on and squeeze closed using crimping tool.
a. Put screw (12) through end of clamp (11) and
frame (2) and hook spring (13) on screw.
b. Put Iockwasher (10) and nut (9) on screw (12).
c. Tighten using no. 2 cross-tip screwdriver and
Z6 in. open-end wrench.
4-37
Back to Top
