TM-9-2330-247-14-P
CHASSIS, TRAILER: GENERAL PURPOSE, 3-1/2 TON, 2-WHEEL, M353
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS)
MARCH 1992
TM-9-2330-247-14-P - Page 86 of 320
TM 9-2330-247-14&P
4-26. CHASSIS WIRING HARNESS (Con’t)
ACTION
LOCATION
ITEM
REMARKS
CIRCUIT MARKER BAND REPLACEMENT
26.
Wire lead (22)
Marker band (29)
Using ~ in. flat-tip screwdriver, open tab ends and
take off.
Note number on marker band (29) and
discard.
27.
New marker
a. Using etcher, etch proper number.
band (29)
If number is missing or illegible, refer to
wiring diagrams (para 4-28).
b. Place on wire lead (22) and bend tab ends over
wire using crimping tool.
INSTALLATION
28.
Frame (7)
29.
Chassis wiring
harness (3)
30.
Frame (7)
31.
Two clips (21),
two rear corner
clips (12),
and frame (7)
Chassis wiring
Lay out over trailer crossbeams
harness (3)
Connectors
Feed through proper frame holes (8).
(14 and 19)
Two clips (21) and
Place clips on frame and line up screw holes.
two rear corner
clips (12)
Eight screws (11),
a. Put screws through frame and clip screw holes.
nuts (9), and
b. Put Iockwashers on nuts and screws and tighten
Iockwashers (10)
using no. 2 cross-tip screwdriver and ~G in.
open-end wrench.
NOTE
When connecting chassis wiring harness connectors to light
assemblies and intervehicular cable connectors, ensure that
wire numbers match. Refer to wiring diagrams (para 4-28).
32.
Intervehicular cable
12 connectors
Apply insulating compound to male connectors
connector leads (17)
(18 and 19)
(19), Put together connectors and push into clips
and chassis wiring
(21),
harness leads (20)
TA701060
4-32
Back to Top
