TM-9-2330-247-14-P
CHASSIS, TRAILER: GENERAL PURPOSE, 3-1/2 TON, 2-WHEEL, M353
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS)
MARCH 1992
TM-9-2330-247-14-P - Page 76 of 320
TM 9-2330-247-14&P
4-25. BLACKOUT STOPLIGHT ASSEMBLY
This Task Covers:
a.
Removal
c.
Installation
b. Lamp, Lens, and Door Assembly Replacement
Initial Setup:
Equipment Conditions:
Tools/Test Equipment:
l Intervehicular cable disconnected from towing ve-
l Handle, ratchet, 3/8 in. drive
hicle (para 2-12).
l Screwdriver, flat-tip, 1/4 in.
c Socket, 3/8 in. drive, 1/2 in.
NOTE
l If wire connectors are to be repaired or replaced, refer to chassis wiring harness task
(para 4-26).
. Removal is not necessary for lamp, lens, or door assembly replacement. If replacing
lamp, lens, or door assembly only, go to step 4. If circuit marker bands are missing or
illegible, replace (para 4-26).
REMOVAL
1.
Blackout stoplight
Connector (2)
Pull out.
assembly (1)
2.
Bracket (5) and
Screw (6) and
Using 1/2 in. socket and ratchet handle with 3/8 in.
blackout stoplight
Iockwasher (7)
drive, unscrew and take out.
assembly (1)
3.
Bracket (5)
Blackout stoplight
Lift up and take off.
assembly (1)
4-22
Back to Top
