TM-9-2330-335-14-P
SEMITRAILER, TACTICAL, BREAKBULK/CONTAINER TRANSPORTER, 22-1/2 TON, RESET M871R, M871A1R AND M871A2R
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE MANUAL (INCLUDES REPAIR PARTS AND SPECIAL TOOLS LIST)
SEPTEMBER 2008
TM-9-2330-335-14-P - Page 287 of 640
0061-1
TM 9-2330-335-14&P
0061
ORGANIZATIONAL MAINTENANCE
-
DECALS AND DATA PLATES REPLACEMENT
Removal, Installation, Decals and Data Plates
REMOVAL
00061
NOTE
Transcribe pertinent information onto new decals and data plates.
1.
Drill out/chisel four rivets (Figure 2, Item 9) and remove lifting/tiedown data plate (Figures 2, 3, and 5, Item 10)
and lubrication data plate (Figures 2 and 5, Item 8) from semitrailer. Discard rivets.
2.
Remove automatic slack adjusters notice decal (Figures 1 and 4, Item 5), hubs information/warning decal
(Figures 1 and 4, Item 6), two UID decals (Figures 1, 4, and 5, Item 3), inspection decal (Figures 1 and 4, Item 2), gross
axle weight rating decal (Figures 1 and 5, Item 4), final inspection decal (Figures 1 and 4, Item 1), and torque decal
(Figures 2 and 5, Item 7) from semitrailer. Discard labels.
END OF TASK
INSTALLATION
00061
1.
Install new torque decal (Figures 2 and 5, Item 7), final inspection decal (Figures 1 and 4, Item 1), gross axle
weight rating decal (Figures 1 and 5, Item 4), inspection decal (Figures 1 and 4, Item 2), two UID decals (Figures
1, 4, and 5, Item 3), hubs information/warning decal (Figures 1 and 4, Item 6), and automatic slack adjusters
notice decal
(Figures 1 and 4, Item 5) on semitrailer.
2.
Install lubrication data plate (Figures 2 and 5, Item 8) and lifting/tiedown data plate (Figures 2, 3, and 5, Item 10) using
eight new rivets (Figure 2, Item 9).
END OF TASK
INITIAL SETUP
Maintenance Level
0
Organizational
0
Tools and Special Tools
0
Tool kit, general mechanic’s (Item 4, WP 0082)
0
Materials/Parts
0
Rivet (8)
0
Equipment Conditions
0
Landing legs down
0
Semitrailer disconnected from prime mover
0
Tires chocked
0
Ground boards emplaced
0
6
Back to Top
