TM-9-2330-342-10

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; OPERATOR'S MANUAL

SEPTEMBER 2012

TM-9-2330-342-10 - Page 278 of 500

TRANSFER CONTAINER FROM VEHICLE TO TRAILER - Continued

CAUTION

•

Vehicle must be aligned with trailer. Failure to comply may result

in damage to equipment.

•

Both of the bumper points must be under the vehicle bumper

plate flange and at least one of the bumper points must contact

the bumper plate. The bumper point not contacting the bumper

plate cannot exceed 0.5 in. (12.7 mm) distance from bumper

plate or container will not load properly. Failure to comply may

result in damage to equipment.

19.

With the aid of an assistant, back up vehicle so that bumper attachment (Figure 4,

Item 3) is under bumper plate flange (Figure 4, Item 2) and is in contact with bumper

plate (Figure 4, Item 1). Refer to vehicle Operator's manual (WP

0057).

1

2

3

Figure 4.

Transfer Container From Vehicle To Trailer With ECHU.

20.

Apply service brake pedal. Refer to vehicle Operator's manual (WP

0057).

21.

Place transmission range selector to NEUTRAL. Refer to vehicle Operator's manual

(WP

0057).

22.

Apply parking brake. Refer to vehicle Operator's manual (WP

0057).

NOTE

Left side and right side container locks are unlocked the same way. Left

side shown.

23.

Remove lynch pin (Figure 5, Item 2) from hitch pin (Figure 5, Item 1).

TM 9-2330-342-10

0027

0027-6