TM-9-2330-342-23-P
PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1
TECHNICAL MANUAL; FIELD MANUAL
OCTOBER 2012
TM-9-2330-342-23-P - Page 150 of 1348
CONDITION/INDICATION
Does test equipment pass offset test?
DECISION
Yes - Go to (Step 6 - Is continuity measured between rear marker light ground contact and a known good
ground?).
No - Test equipment failed offset. Contact your Supervisor.
STEP 6
Is continuity measured between rear marker light ground contact and a known good ground?
1.
Remove two screws and lens cover (WP
0057).
GROUND
CONTACT
SCREWS
CENTER MARKER
LIGHT SHOWN
OTHERS SIMILAR
Figure 6.
Rear Marker Lights and Ground Contact.
2.
Connect button probe cable red lead to rear marker light ground contact.
3.
Connect button probe cable black lead to a known good ground.
4.
Perform ICE Test 91.
5.
Meter should display a reading less than 200 ohms.
CONDITION/INDICATION
Is continuity measured between rear marker light ground contact and a known good ground?
DECISION
Yes - Replace rear marker light assembly (WP
0057). Go to (Step 8 - Do all rear marker lights operate?) to verify
problem is solved.
No - Go to (Step 7 - Can rear marker light harness wire 1435 be repaired?).
TM 9-2330-342-23&P
0009
0009-6
Back to Top
