TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 1070 of 1364

TM 9-2350-238-20-1

2-182. MAINTENANCE OF HEATER INSTALLATION KIT—ELECTRICAL WIRING (CONT).

Failure to remove or disconnect batteries before removing or installing any electrical

lead or wiring harness may result in injury or damage to equipment.

NOTE

Tag all electrical leads during removal to aid in installation.

1

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. Remove only the hardware which secures the harness or lead being

removed.

2

Tag and disconnect bulkhead disconnects to master relay and circuit breaker special cable

assembly (1) plug connector from vehicle bus receptacle connector (2).

3

Tag and disconnect six shell connectors (3) from line connections.

4

Remove four screws (4) and receptacle connector (5) from bulkhead disconnect. Tag and

disconnect bulkhead disconnects to master relay and circuit breaker special cable assembly (8).

from bulkhead disconnect and remove gasket (6).

5

Tag and disconnect plug connector (7) from master relay assembly (8).

2-1044