TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 1073 of 1364

TM 9-2350-238-20-1

1

Untag and connect heater control box to driver’s heater wiring harness (1) plug connector to

vehicular heater (2).

2

Untag and connect plug connector (3) to driver’s heater electrical control box (4).

3

Untag and connect shell connector (5) to line connection.

4

Untag and connect cable terminal (6) to dome light assembly (7).

5

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. During installation, make sure the wiring harness or lead is secure

and all hardware is tight.

1

Untag and connect bulkhead disconnects to master relay and circuit breaker special cable

assembly (1) plug connector to master relay assembly (2).

2

Install new gasket (3) and connect bulkhead disconnects to master relay and circuit breaker

special cable assembly (1) to bulkhead disconnect. Secure receptacle connector (4) with four

screws (5).

3

Untag and connect six shell connectors (6) to line connections.

4

Untag and connect plug connector (7) to vehicle bus receptacle connector.

5

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. During installation, make sure the wiring harness or lead is secure

and all hardware is tight.

2-1047