TM 9-2350-238-20-1
Failure to remove or disconnect batteries before removing or installing any electrical
lead or wiring harness may result in injury or damage to equipment.
NOTE
Tag all electrical leads during removal to aid in installation.
1
Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,
clips, ground screws, etc. Remove only the hardware which secures the harness or lead being
removed.
2
Tag and disconnect battery positive
positive terminal (2).
3
Remove battery positive terminal to
breaker (3).
4
Tag and disconnect battery positive
positive terminal (5).
5
Remove battery positive terminal to
terminal to circuit breaker electrical lead (1) from battery
circuit breaker electrical lead (1) from coolant heater circuit
terminal to circuit breaker electrical lead (4) from battery
circuit breaker electrical lead (4) from circuit breaker (6).
2-1041