TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 1114 of 1364

TM 9-2350-238-20-1

2-191. MAINTENANCE OF VEHICULAR WINDOW (DRIVER’S WINDSHIELD ENCLO-

SURE KIT) (CONT).

REASSEMBLY (CONT)

7

8

9

Install window assembly to windshield

assembly cylinder fastener (20), two

machine screws (21), two flat washers

(22), and two new self-locking nuts (23).

Install two window catch pads (24), four

new lockwashers (25), and four machine

screws (26).

Install two window assembly to windshield

assembly cylinder fasteners (27), four new

Iockwashers (28), and four machine

screws (29).

2-192. MAINTENANCE OF OIL RESERVOIR HEATER KIT AND ELECTRICAL WIRING.

This task covers:

a.

Removal

d.

Reassembly

b.

Disassembly

e. Installation

c. Inspection/Repair

INITIAL SETUP

Tools and Special Tools

References

Automotive maintenance and repair shop

TB SIG-222

equipment: organizational maintenance,

TM 9-2350-238-24P-1

common no. 1 (less power) (item 80,

appx B)

Equipment Conditions

Electrical connector repair tool kit

2-384 Hydraulic oil resevoir drained

Hand wire stripper

Soldering gun

General Safety Instructions

Materials/Parts

Electrical wire (figure D-2, appx D)

Heater assembly gasket

Failure to remove or disconnect

LockWasher (4)

batteries before removing or installing

LockWasher (4)

any electrical wiring harness or lead

Solder (item 43, appx C)

may result in injury or damaged

equipment.

2-1088