TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

  TM-9-2350-238-20-1 - Page 1161 of 1364

TM 9-2350-238-20-1
1
2
3
4
5
6
7
8
9
Align base assembly (1) with four screw holes and install four new Iockwashers (2) and four
hexagon head capscrews (3).
Position upper half of windshield to base butt hinge (4) on vehicular window (5). Align holes,
and install two machine screws (6), two flat washers (7), and two new self-locking nuts (8).
Position upper half of windshield to base butt hinge (9) on vehicular window (5). Align holes,
and install three machine screws (10), three flat washers (11), and three new self-locking nuts
(12) .
Install vehicular window (5) on base assembly (1).
Position lower half of windshield to base butt hinge (13) on base assembly (1), align holes, and
install two machine screws (14), two flat washers (15), and two new self-locking nuts (16).
Align holes in upper (4) and lower (13) halves of windshield to base butt hinge, and secure by
installing hinge to base pin assembly (17) and new cotter pin (18).
Position lower half of windshield to base butt hinge (19) on base assembly (1), align holes, and
install three machine screws (20), three flat washers (21), and three new self-locking nuts (22).
Align holes in upper (9) and lower (19) halves of windshield to base butt hinge, and secure by
installing hinge to base pin assembly (23) and new cotter pin (24).
Position window assembly (25) on base assembly (1). Latch three window assembly to
windshield assembly cylinder fasteners (26), and connect window assembly chains (27) on both
sides of window assembly.
2-1135


Back to Top