TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

  TM-9-2350-238-20-1 - Page 1170 of 1364

TM 9-2350-238-20-1
2-200. MAINTENANCE OF CRANE OPERATOR’S BASE ASSEMBLY (CONT).
REASSEMBLY
1
Roughen bonding surfaces with flint
abrasive paper.
Dry cleaning solvent (SD2) is toxic
and flammable. Wear protective
goggles and gloves and use only in a
well-ventilated area.
2
Apply dry cleaning solvent to bonding
surfaces to remove any grease. Dry
surface thoroughly.
5
Install two nonmetallic grommets (5) in
base (4).
6
Cut nonmetallic channel (6) as necessary
around grommets. Apply adhesive to
nonmetallic channel (6) and install on base
(4) .
7
Install
4
hull brackets (7), 12 flat washers
(8), 12 machine screws (9), and 12 new
self-locking nuts (10).
8
Install two base links (11), four flat
washers (12), four machine screws (13),
3
Apply adhesive
tape strips (2).
4
Apply adhesive
on base (4).
to two seals (1) and two
and four new self-locking nuts (14) on
Install seals on tape strips.
base. Bend if necessary.
to tape strip (3) and install
9
Install two flat washers (15), two hexagon
plain nuts (16), two machine screws (17),
two flat washers (18), and two hexagon
plain nuts (19) on base (4).
2-1144


Back to Top