TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 173 of 1364

TM 9-2350-238-20-1

Step 13.

Disconnect electrical lead (lead 82) and wiring harness at engine

disconnect. Place insulated jumper wire to pin B (lead 1). Set MASTER

switch ON. Strike jumper wire to socket (lead 82). Connect leads and go

back to step 12.

Step 14.

Temporarily replace voltage regulator. Refer to page 2-557. Perform

generator-regulator charging circuit test. Refer to page 2-138. If

generator-regulator charging circuit operates properly, permanently replace

voltage regulator. Refer to page 2-557. If generator-regulator charging

circuit does not operate properly, remove temporary voltage regulator and

replace generator. Refer to page 2-552. After replacing generator,

perform generator-regulator charging circuit test. Refer to page 2-138.

2-147