TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 192 of 1364

TM 9-2350-238-20-1

2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).

Make sure MASTER switch is OFF before repairing

electrical circuits. Failure to observe this warning

could result in injury to personnel.

Step 2.

Disconnect wiring harness from instrument (gage) panel. Place red probe

on pin F (lead 27) of receptacle. Ground black probe. Set MASTER and

INST switches ON. If multimeter indicates no voltage, repair lead 27 from

INST switch to receptacle. Refer to page 2-371. If multimeter indicates

about

24

volts, repair lead 27 from plug to instruments. Refer to page

2-371. Set MASTER and INST switches OFF. Connect wiring harness to

instrument (gage) panel.

2-166