TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 883 of 1364

TM 9-2350-238-20-1

10

11

12

13

15

16

17

18

19

20

21

22

23

To gain access to lockout cylinder assem-

bly, refer to page 2-831.

Using sling, support lockout cylinder

assembly (7).

Remove two cotter pins (8).

Remove straight headless pin (9), using

puller.

Using sling, remove lockout cylinder

assembly (7) from roadwheel lever (10).

Install two threaded straight pins into

opposing capscrew holes.

Install three hexagon head capscrews into

capscrew holes.

Screw puller adapter into pivot arm

assembly (3).

Screw slide puller into puller adapter.

Tighten three hexagon head capscrews

evenly. At the same time, using slide

puller, withdraw pivot arm assembly (4)

about 5.0 in. (12.7 cm) from hull.

Support pivot arm assembly (4).

Remove slide puller and puller adapter.

Remove three hexagon head capscrews.

Remove pivot arm assembly (4).

Remove threaded straight pins.

Lift roadwheel lever (10), and remove from

hull.

2-857