TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 921 of 1364

TM 9-2350-238-20-1

●

●

●

To avoid injury to personnel, do not tighten or loosen hydraulic fittings when system

is pressurized.

Lower the boom to stowed position before doing any maintenance on hydraulic

system.

Wipe up any spilled hydraulic fluid to prevent injury to personnel.

Install covers on open

disconnecting them to

Access to suspension

hydraulic ports, tubes, and hoses immediately after

keep dirt out of hydraulic system.

NOTE

system hydraulic fittings is gained through the cab well.

1

Disconnect nonmetallic hose assembly (1) from tube elbow (2).

2

Loosen locknut (3) on tube elbow (2).

3

Remove tube elbow (2) with locknut (3), flat washer (4), and preformed packing (5) from lockout

cylinder (6).

4

Remove preformed packing (5), flat washer (4), and locknut (3) from tube elbow (2).

2-895