TM-9-2350-238-34-1
HULL AND RELATED COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
MARCH 1994
TM-9-2350-238-34-1 - Page 201 of 292
WARNING
TM 9-2350-238-34-1
CHAPTER 3
GENERAL SUPPORT MAINTENANCE INSTRUCTION S
CHAPTER INDE X
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
........................
3-1
Maintenance of Double Rotary Pump . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-15
Maintenance of Pump and Slip Ring Assembly and Attaching Parts.
.. . . . . . . . . . . . . . . .
.......
. 3-4
Maintenance of Slip Ring Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
.........
..........
. 3-12
Maintenance of Hydraulic Suspension Lockout Cylinder Assembly . . . .
..................
. . . . . . . . . . . . . . . . 3-33
Maintenance of Transmission Power Takeoff . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-45
Painting Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-1
Troubleshooting lnformation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
..3-1
Section I. GENERAL SUPPORT GENERAL MAINTENANCE PROCEDURE S
3-1. GENERAL.
This section contains general repair methods and painting procedures. Specia l
repair methods and cleaning procedures are provided, as required, in the individual maintenance
instructions. For repair methods and cleaning procedures not found in this section, refer to page 2-
2-29 of this manual.
3-2. PAINTING PROCEDURES .
Unusable CARC mixtures may be considered hazardous waste and may requir e
disposal in accordance with Federal, state, DOD, and DA hazardous waste regula-
tions. Consult the installation environmental office for proper disposal guidance.
Mixed CARC has a flashpoint of approximately 38 °F (3 °C) due to the incorporation
of solvents and is highly flammable .
Complete painting is authorized for and done by general support maintenance personnel or higher.
CARC paint that has been opened must be used within 8 hours or it will deteriorate beyond use.
Mix only what is needed for immediate use. instructions for materiel preparation, priming, and finish
are given in TM 43-0139 .
Section Il. GENERAL SUPPORT TROUBLESHOOTIN G
3-3. TROUBLESHOOTING INFORMATION .
a.
The symptom index can be used as a quick guide to troubleshooting. Common malfunctions
are listed in alphabetical order under each major assembly, which appear in MAC order, with a page
number reference to the troubleshooting table where a test or inspection and corrective action are
provided .
3-1
Back to Top
