TM-9-2350-238-34-2

CRANE (CAB) COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

APRIL 1992

TM-9-2350-238-34-2 - Page 156 of 327

TM 9-2350-238-34-2

INSPECTION/REPAIR

1 Inspect for broken, damaged, or missing parts.

2 If carrier is broken, damaged, or missing, repair is by replacement of next higher assembly

3 If any kit component is damaged, replace entire parts kit.

4 Repair is by replacement of authorized parts (TM 9-2350-238-24P-2).

REASSEMBLY

NOTE

If retaining stop ring and spur gear

shaft were removed, new welds are

necessary during reassembly.

1 If removed, install new retaining stop ring

(1) in groove in spur gear shaft (2).

2 Insert spur gear (2) into carrier (3), seating

retaining stop ring (1) firmly against

carrier.

Weld retaining stop ring to carrier.

Do not weld to spur gear.

3 Weld retaining stop ring (1) to carrier (3)

with 0.12-in. (0.30-cm) fillet welds. Weld

three 1.00-in. (2.54-cm) spots placed an

equal distance apart around circle of re-

taining stop ring. Weld per MIL-STD-

1261C(MR).

ARBOR

PRESS

4 Using arbor press, install three roller bear-

ings (4) in three planet pinion gears (5).

2-143