TM-9-2350-238-34-2

CRANE (CAB) COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

APRIL 1992

TM-9-2350-238-34-2 - Page 157 of 327

TM 9-2350-238-34-2

2-33. MAINTENANCE OF STAGE THREE CARRIER ASSEMBLY (CONT).

REASSEMBLY (CONT)

5 Using hammer and punch, peen lip of

each of three planet pinion gears (5) in

four equally spaced places around each

roller bearing (4).

6 Install three planet pinion gears (5) and six

pinion gear flat washers (6) each, in car-

rier (3).

7 Install three new gear pins (7) in carrier

(3).

NOTE

●

If a new carrier is used, drill and

tap

a

0.250-in.(0.635-cm),

28

UNF-2B hole 0.375 in. (0.953

cm) deep between each gear

pin and carrier.

●

If only new gear pins are used,

drill and tap a new hole be-

tween each new gear pin and

carrier. Drill new holes approx-

imately 180 degrees from old

holes.

OLD HOLES

8 Install three new setscrews (8) in carrier

(3). Tighten and stake each new

setscrew.

NEW HOLES

2-144