TM-9-2350-238-34-2
CRANE (CAB) COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
APRIL 1992
TM-9-2350-238-34-2 - Page 92 of 327
TM 9-2350-238-34-2
6 If necessary, grind welds securing retain-
ing stop ring (7) to carrier (2), and remove
spur gear (8) and retaining stop ring.
1 Inspect for broken, damaged, or missing parts.
2 If carrier is broken, damaged, or missing, repair is by replacement of next higher assembly.
3 If any kit component is damaged, replace entire hydraulic parts kit.
4 Repair is by replacement of authorized parts (TM 9-2350-238-24P-2).
REASSEMBLY
NOTE
If retaining stop ring and spur gear
were removed, new welds are
necessary during reassembly.
1 If removed, install new retaining stop ring
(1) in groove in spur gear (2).
2 Insert spur gear (2) into carrier (3), seating
retaining stop ring (1 ) firmly against
carrier.
Weld retaining stop ring to carrier.
Do not weld to spur gear.
3 Weld retaining stop ring (1) to carrier (3)
with 0.12-in. (0.30-cm) fillet welds. Weld
three 1.00-in. (2.54-cm) spots placed an
equal distance apart around circle of re-
taining stop ring (1). Weld per MIL-
STD-1261C (MR).
2-79
Back to Top
