TM-9-2350-238-34-2
CRANE (CAB) COMPONENTS, RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL
APRIL 1992
TM-9-2350-238-34-2 - Page 95 of 327
TM 9-2350-238-34-2
2-27. MAINTENANCE OF STAGE THREE BOOM WINCH CARRIER ASSEMBLY {CONT).
DISASSEMBLY (CONT)
Clutch release carrier contains spring
under high tension. Use caution dur-
ing removal.
6 Using arbor press, compress helical com-
pression spring (9) inside body of clutch
release carrier (2) and using retaining ring
pliers, remove retaining ring (10). Slowly
release pressure on body of clutch release
carrier.
7 Remove spring stop (11) and helical com-
pression spring (9) from reaction shaft of
clutch release carrier (2).
INSPECTION/REPAIR
1 Inspect for broken, damaged, or missing parts
2 If clutch release carrier is broken, damaged, or missing, repair is by replacement of next
higher assembly,
3 If any kit component is damaged, replace entire carrier assembly parts kit.
4
Repair is by replacement of authorized parts (TM 9-2350-238-24P-2).
REASSEMBLY
1
2
3
Install helical compression spring (1) and
spring stop (2) in body of clutch release
carrier (3).
Clutch release carrier contains spring
under high tension. Use caution dur-
ing installation.
Using arbor press, compress helical com-
pression spring (1) and spring stop (2) in-
side body of clutch release carrier (3).
Using retaining ring pliers, install new re-
taining ring (4) on body of clutch release
carrier (3). Slowly release pressure and
remove clutch release carrier from arbor
press.
2-82
Back to Top
