TM-9-2350-256-10

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

OPERATOR'S MANUAL

OCTOBER 2014

  TM-9-2350-256-10 - Page 215 of 796

EXITING AND RE-ENTERING VEHICLE WITH THE DRIVER'S VISION ENHANCER (DVE) INSTALLED -
Continued
2.
Ensure DCM POWER switch (Figure 13, Item 3) is set to OFF position.
3.
Hold bottom of sensor assembly (Figure 13, Item 1) to prevent it from falling.
4.
Open locking handle (Figure 13, Item 4) by holding locking latch forward and pulling handle down and to
rear.
5.
Rotate sensor assembly (Figure 13, Item 1) down and remove from periscope mount (Figure 13, Item 5).
6.
Rotate locking handle (Figure 13, Item 4) forward to latched position.
7.
Hang sensor assembly (Figure 13, Item 1) on T-handle knob (Figure 13, Item 6) located on right side of
DCM (Figure 13, Item 2).
8.
Open hatch (WP 0025) and exit.
Re-entering Vehicle
1.
Re-enter vehicle, secure hatch (WP 0025).
2.
Remove sensor assembly (Figure 13, Item 1) from T-handle knob (Figure 13, Item 6) on DCM
(Figure 13, Item 2).
3.
Open periscope-locking handle (Figure 13, Item 4) by holding locking latch forward and pulling handle down
and to rear.
4.
Turn infrared window of sensor assembly (Figure 13, Item 1) to front of vehicle. Place front edge of sensor
assembly in seat of periscope mount (Figure 13, Item 5) at front of periscope opening. Push up slightly on
rear and rotate locking handle (Figure 13, Item 4) forward to lock sensor assembly into place.
5.
Ensure sensor assembly (Figure 13, Item 1) is locked in center position.
Figure 13.
DCM and Sensor Assembly.
TM 9-2350-256-10
0040
0040-13


Back to Top