TM-9-2350-256-10

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

OPERATOR'S MANUAL

OCTOBER 2014

  TM-9-2350-256-10 - Page 213 of 796

DRIVER'S VISION ENHANCER (DVE) SENSOR ASSEMBLY REMOVAL
1.
Hold bottom of sensor assembly (Figure 11, Item 2) to prevent it from falling.
2.
Open periscope locking handle (Figure 11, Item 5) by holding locking latch forward and pull handle down
and to rear.
3.
Rotate sensor assembly (Figure 11, Item 2) down and remove from periscope mount (Figure 11, Item 7).
4.
Close and latch periscope door (Figure 11, Item 6).
5.
Rotate locking handle (Figure 11, Item 5) forward to latched position.
6.
Install sensor assembly protective cover (Figure 11, Item 1) on sensor assembly (Figure 11, Item 2).
7.
Place sensor assembly (Figure 11, Item 2) in DVE stowage case (Figure 11, Item 3). Secure case with
retaining strap (Figure 11, Item 4).
Figure 11.
DVE Sensor Assembly Removal.
END OF TASK
TM 9-2350-256-10
0040
0040-11


Back to Top