TM-9-2350-256-10

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

OPERATOR'S MANUAL

OCTOBER 2014

  TM-9-2350-256-10 - Page 629 of 796

OPERATOR MAINTENANCE
HULL ACCESS COVERS AND GASKETS REMOVAL AND INSTALLATION
INITIAL SETUP:
Tools and Special Tools
General mechanic's tool kit
(WP 0135, Table 1, Item 2)
Suitable container
Wire brush (WP 0135, Table 1, Item 1)
Materials/Parts
Rubber gloves Qty: AR
(WP 0134, Table 1, Item 16)
Materials/Parts (cont.)
Silicone compound Qty: AR
(WP 0134, Table 1, Item 61)
Wiping rags Qty: AR (WP 0134, Table 1, Item 57)
Equipment Condition
Vehicle chocked (WP 0103)
WARNING
Hull access covers weigh more than 10 lb (4.5 kg). Ensure to support access cover
during removal and installation. Failure to comply may cause personnel injury.
Accidental or intentional spillage of contaminants into the environment is a
violation of state, federal, and military regulations. Refer to local environmental
office for information concerning storage, use, and disposal of these liquids.
Failure to comply may result in personnel injury and/or damage to environment.
NOTE
All access covers are removed and installed in the same manner.
TM 9-2350-256-10
0104
0104-1


Back to Top