TM-9-2350-256-10
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
OPERATOR'S MANUAL
OCTOBER 2014
TM-9-2350-256-10 - Page 716 of 796
INCANDESCENT DOME LIGHT LAMP REMOVAL
1.
Loosen eight screws (Figure 2, Item 2) and remove dome light cover from dome light assembly.
2.
Push in and turn lamp (Figure 2, Item 1) or lamp (Figure 2, Item 3) to remove.
END OF TASK
INCANDESCENT DOME LIGHT LAMP INSTALLATION
CAUTION
Ensure dome light assembly is properly positioned on bracket before securing screws to
prevent damage to seal.
1.
Push in and turn new lamp (Figure 2, Item 1) or new lamp (Figure 2, Item 3) to install.
2.
Place dome light cover on dome light assembly and tighten eight screws (Figure 2, Item 2).
Figure 2.
Incandescent Dome Light Lamp Replacement.
END OF TASK
BLACKOUT (BO) MARKER LIGHT LAMP REMOVAL
1.
Loosen four screws (Figure 3, Item 3) and remove cluster cover (Figure 3, Item 1).
2.
Push in and turn blackout driver lamp (Figure 3, Item 2) and remove.
END OF TASK
BLACKOUT (BO) MARKER LIGHT LAMP INSTALLATION
1.
Push in and turn new blackout driver lamp (Figure 3, Item 2) to install.
CAUTION
Ensure cluster cover is properly positioned on headlight assembly before securing screws
to prevent damage to seal.
2.
Place cluster cover (Figure 3, Item 1) in place and tighten four screws (Figure 3, Item 3).
TM 9-2350-256-10
0127
0127-2
Back to Top
