TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 775 of 783

TM 9-2350-260-20-1-3

STEERING CONTROL LINK ASSEMBLY REPLACEMENT (Sheet 3 of 3)

INSTALLATION:

1.

Position link (A) and two washers (B) in control bracket (C).

NOTE

Use hammer if necessary to install

shaft (D).

2.

Install shaft (D) through bracket (C), washers (B),

and link (A) until shaft (D) is flush with bracket (C).

3.

Using adjustable wrench, install setscrew (E) and locknut (F) into bracket (C).

Using 7/16 inch wrench to hold locknut

(F), tighten setscrew (E) into groove of shaft (D).

Tighten locknut (F) against bracket (C).

4.

Using socket, install two bolts (G) through link (A) and two rod end bearings (H).

Using torque wrench, tighten bolts

(G) to 11-21 lb-ft (15-28 N

•

m).

5.

Using 5/16 inch wrench, install grease fitting (J) into link (A).

6.

Close number 5 top deck grille door (TM 9-2350-260-10).

7.

Install transmission shroud (page 9-23).

End of Task

TA146470

15-42