TM-9-2350-261-20-1

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 1 OF 4

TM-9-2350-261-20-1 - Page 153 of 346

TM 9-2350-261-20-1

ENGINE RUNS ROUGH, STALLS, OR DOES NOT PUT OUT FULL POWER — Continued

0013 00

Y

Fuel flowing over a metal surface causes static electricity. This

will cause a spark unless the surface is grounded.

Loose clothing is dangerous around moving belts and pulleys. You

could get badly hurt if your clothes get caught in moving parts.

1.

Insert hose into metal container (1) with at least 1

gallon (4 liter) capacity.

2.

Make sure container (1) is making metal-to-metal contact

with carrier floor so there is a good ground.

3.

Start engine (see your -10). Run engine at 1200 RPM for 1

minute. Hold end of fuel return hose in fuel.

4.

Install rear half of quick disconnect on hose.

5.

Place fuel return hose inside power plant compartment and

connect hose to return line. Make sure quick disconnect

snaps firmly in place.

6.

Did fuel flow at least 1/2 gallon (2 liter) per minute?

YN

GO TO

BY

(PAGE 0013 00-7)

001300-2

WARNING

WARNING